Frame relay gns

Hey Guys,

 I have 3 routers, (r1, r2, r3)

They all need to be connected to a frame relay router. Can that be done in gns? There is a frame relay switch.

Can someone please help with that.
LVL 1
ShivtekAsked:
Who is Participating?
 
HodepineConnect With a Mentor Commented:
You can do two things:

Use the built in frame-relay switch emulation, which I'm sure there are loads of guides of how to set up if you google it.

Or you could set up a router with enough serial interfaces to connect to all routers and do it "properly". I always use this way, so can't really help with the first.

So, to set up a router you need these commands:

frame-relay switching

int ser 0/0
encap frame
frame-relay intf-type dce
clock rate 64000
frame-relay route 122 interface Serial0/1 221

int ser 0/1
encap frame
frame-relay intf-type dce
clocl rate 64000
frame-relay route 221 interface Serial0/0 122

You can have many frame-relay routes pr interface, and if you do show frame-relay pvc on your connected router, you'll which ones are available. I use this all the time in GNS, works like a charm.
0
 
ShivtekAuthor Commented:
This are my configs actually:

R1
interface Serial0/1
 ip address xx.xx.xxx.229 255.255.255.224
 encapsulation frame-relay
 ip ospf authentication message-digest
 ip ospf message-digest-key 1 md5 cisco
 ip ospf network broadcast
 frame-relay map ip xx.xx.xx.231 110 broadcast
 frame-relay map ip xx.xx.xx.230 110 broadcast
 no frame-relay inverse-arp

 R2
interface Serial0/0
 ip address xx.xx.xx.230 255.255.255.224
 encapsulation frame-relay
 ip ospf authentication message-digest
 ip ospf message-digest-key 1 md5 cisco
 ip ospf network broadcast
 ip ospf priority 0
 no fair-queue
 frame-relay map ip xx.xx.xx.231 120 broadcast
 frame-relay map ip xx.xx.xx.229 120 broadcast
 no frame-relay inverse-arp
 frame-relay lmi-type cisco
 
R3
 interface Serial0/1
 ip address xx.xx.xx.231 255.255.255.224
 encapsulation frame-relay
 ip ospf authentication message-digest
 ip ospf message-digest-key 1 md5 cisco
 ip ospf network broadcast
 ip ospf priority 200
 frame-relay map ip xx.xx.xx.230 102 broadcast
 frame-relay map ip xx.xx.xx.229 101 broadcast
 no frame-relay inverse-arp

I am attaching the topology I have in gns. R4 is actually the ISP.

I need your help entering the DLCI's in the frame relay switch and how would they be connected.
Thanks

Picture1.png
Picture2.png
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.