cisco mds cancel zone changes

Hello Gurus,
  Came across this problem and not sure how to address it. I want to make zone changes in my MDS via the Fabric Manager and there are stale changes requesting to be activated. How do I cancel those changes so that I can only activate my changes?

Thanks....
alcsmithAsked:
Who is Participating?
 
Duncan MeyersConnect With a Mentor Commented:
One way is to compare the running config against the startup config from the CLI. If the startup config is OK, do a "copy start run" and the startup config will overwrite any changes you'va made to the running config - be careful, though.

You may need to restart Fabric Mangler, but it should catch up OK.
0
 
etaljicConnect With a Mentor Commented:
In Fabric Manager when you activate your zoneset it will ask you whether or not you want to review what will be added/deleted before proceeding. If you state yes (to view the changes before committing) you'll see a list of those changes. Do not proceed at that screen but note the additions/deletions of zones. All you have to do is go to the zoneset on the left-hand side and remove those zones from the zoneset. You will also need to re-add the zones if zones were listed to be removed. You are basically undoing what the last person did.
0
 
QlemoBatchelor, Developer and EE Topic AdvisorCommented:
This question has been classified as abandoned and is being closed as part of the Cleanup Program.  See my comment at the end of the question for more details.
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.