Routing and Remote access VPN

I have a Windows 2003 server that is a DC, DNS, DHCP and Routing and Remote access server for VPN's.

The external interface is on 172.16.0.10 and the internal is on 192.168.0.10. I have noticed that when a VPN connection is attempted, the SYN packet arrives on the external interface but the SYN ACK is sent out through the internal interface with a source address of 172.16.0.10.

The default gateway is set on the internal interface currently as 192.168.0.1. How can I get the VPN server to reply on the correct interface?
LVL 1
partymarty84Asked:
Who is Participating?
 
partymarty84Author Commented:
MS recommended setting up VPN with only one interface. Problem solved.
0
 
samieranaCommented:
Add route to your routing table
which ip-address traffic should go to which gate-way
0
 
partymarty84Author Commented:
172.16.0.x traffic is already told to route through 172.16.0.10 but it doesn't do it.
0
 
samieranaCommented:
Can you upload your routing table here if your problem is not yet solved?
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.