Windows could not complete the installation. To install Windows on this computer, restart the installation." appears in mini setup stage after Restore Anywhere completes

I am trying to do back restore with back exec 8.5 using  restore anyware everything goes well until the last step wich window if finalizing a error window come out and say Windows could not complete the installation. To install Windows on this computer, restart the installation." appears in mini setup stage after Restore Anywhere completes , i tryed to switch to vga mode like symantec said nothing, put a diferent video card, nothing, any ideas thank you.
 
 
MarioQuinAsked:
Who is Participating?
 
Syed Mutahir AliTechnology ConsultantCommented:
Try the following, I had a similar error doing a test restore and I did the following :

When Restoring from BESR to a new / disimilar hardware :

Restore with Restore Anywhere,
""""Hold down the ctrl key while selecting Restore Anywhere"""""

"""Un-check Invoke Mini Setup"""
0
 
Syed Mutahir AliTechnology ConsultantCommented:
The Windows user Administrator is not active or is renamed and Sysprep need the Administrator to complete the mini setup.

http://seer.entsupport.symantec.com/docs/317514.htm

As per the article posted by Expert, it is because it is inovoking sysprep which will change the SIDs too, thus spoiling your exchange install, I would recommend to use the "CTRL KEY and Uncheck Invoke Mini Setup" to get pass through.

If it doesn't helps then follow the article
0
 
MarioQuinAuthor Commented:
Thank you , this one work like you said, i am doing a lot test so i can learn more with this software.
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.