I have 2 cards installed for my cisco 2801 flash:c2801-spservicesk9-mz.124-24.T2.bin
with CME 7.1. The cards i got are 2port-vic3-2fxs/DID and 2port-vic2-2fxo.
This is the only router which has both multiple IP phones and and 1analog phone connected in it.
The PSTN analog phone: 1-705-267-6097 is connected to the FXS port 0/0/0 and the FXO port 0/1/0 is connected to the PSTN rj11 wall jack.
Since both types of phones (IP and analog) are connected to the same router do i need to configure both pots dial-peers and voip dial-peers in order for this to work and utilize voip the way it should work?
If i do have to create voip dial peers is the session target ipv4: command required and should point to itself since it's all in the same router?
thanks for the help