ticowarehouse
asked on
Cisco Pix 6.3 Nat Global question
Experts,
I am a little rusty, Which Nat/Global is applied here
Pix(config)# sh nat
nat (inside) 1 0.0.0.0 0.0.0.0 0 0
nat (dmz1) 1 0.0.0.0 0.0.0.0 0 0
PerFW(config)# sh gl
global (outside) 1 172.16.5.4 netmask 255.255.255.0
global (dmz1) 1 172.16.3.49 netmask 255.255.255.255
global (dmz2) 1 172.16.9.48
global (dmz3) 1 172.16.4.2
global (dmz4) 1 172.16.7.2
I am a little rusty, Which Nat/Global is applied here
Pix(config)# sh nat
nat (inside) 1 0.0.0.0 0.0.0.0 0 0
nat (dmz1) 1 0.0.0.0 0.0.0.0 0 0
PerFW(config)# sh gl
global (outside) 1 172.16.5.4 netmask 255.255.255.0
global (dmz1) 1 172.16.3.49 netmask 255.255.255.255
global (dmz2) 1 172.16.9.48
global (dmz3) 1 172.16.4.2
global (dmz4) 1 172.16.7.2
Not sure what you're asking. You have a global NAT for the outside interface and several other DMZ global NATs associated to your DMZ defined interfaces. What exactly are you trying to do?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I believe that these are not being used because they don't have a nat rule associated to them.
global (dmz2) 1 172.16.9.48
global (dmz3) 1 172.16.4.2
global (dmz4) 1 172.16.7.2
global (dmz2) 1 172.16.9.48
global (dmz3) 1 172.16.4.2
global (dmz4) 1 172.16.7.2