Basic programming of Cisco 881-W

I have a client who just purchased a Cisco 881-W router.  He purchased the unit about two months ago, used from another vendor.  According to the vendor, the unit was put back to factory default settings.  I am not very versed in Cisco programming, but have heard that they created a GUI program that makes it very easy to program their routers/firewalls now.  Can anyone please point me in the right direction on this?  I am very versed at other manufactures (eg:  SonicWall, 3Com, etc.).  I have gone to the Cisco website and it is simply a nightmare to locate what I need.  I just need basic programming:  WAN side, One LAN side, basic ACL list.
LVL 1
YortAsked:
Who is Participating?
 
Don JohnstonInstructorCommented:
Yes, it should have an IP address of 10.1.1.1 on the Fastethernet 0/0 interface.

Here's a guide:

http://www.cisco.com/en/US/docs/routers/access/800/860-880-890/software/configuration/guide/routconf.html

If SDM is loaded, you should be able to put in http://10.1.1.1 in the address bar of your browser and configure the router that way.

Otherwise, it's the CLI from the console port.

0
 
Istvan KalmarHead of IT Security Division Commented:
ok
please show us the blank config, and the network topology and we give you config
0
 
YortAuthor Commented:
ikalmar:  Thank you for your quick response.  How do I show you the blank config?
0
 
Istvan KalmarHead of IT Security Division Commented:
'show run' commands tell it
0
 
YortAuthor Commented:
thanks...i will do that and post it here as soon as I can
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.