Configuring Cisco SFP to speed cap at 100Mbps

I have a Cisco 2940 switch with 1000Base-SX SFP.  I want this fiber port to communicate at 100Mbps not 1000.  This is becuase we have touchy network equipment that needs to have 100mbps and not 1000.  How would I go about doing this?  When I type the following:

en
config t
int gi0/1

when I type "speed ?" there is not a speed option.  Is it possible for me to throddle this back?  I use a GLC-SX-MM sfp.  The swtich is a cisco catalyst 2940 series switch.

Thanks,
Donald
LVL 2
Donald_GibsonAsked:
Who is Participating?
 
that1guy15Commented:
yeah SFPs do not give you an option to run at 100Mbps just 1000Mbps.

If the equipment needs to have a connection speed of 100Mbps then you are not going to be able to use these ports.


0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.