cisco asa 5510

i want to connect port 0 to cable modem get dynamic ip address then port 1 connect to a switch. port 1 wil run dhcp. I need basic set up internal network connect to internet.
Who is Participating?
I wear a lot of hats...

"The solutions and answers provided on Experts Exchange have been extremely helpful to me over the last few years. I wear a lot of hats - Developer, Database Administrator, Help Desk, etc., so I know a lot of things but not a lot about one thing. Experts Exchange gives me answers from people who do know a lot about one thing, in a easy to use platform." -Todd S.

Cisco has the basic setup examples here...   just follow the basics first.    If you have issues, then post your code and we can have a look.

basic setup

asa as dhcp

The commands to have the external interface get a dhcp address is as follows:
interface Vlan2
nameif outside
security-level 0
ip address dhcp setroute

Experts Exchange Solution brought to you by

Your issues matter to us.

Facing a tech roadblock? Get the help and guidance you need from experienced professionals who care. Ask your question anytime, anywhere, with no hassle.

Start your 7-day free trial
marius_rAuthor Commented:
I did very quick set up, there are showing two static routers  at very end why do I need them both?
You should only have 1 catch all route to the outside for     You would use additional statics to the inside if you have some downstream routers with other subnets.     So it kind of depends if you have other subnets that the ASA needs to know about.
It's more than this solution.Get answers and train to solve all your tech problems - anytime, anywhere.Try it for free Edge Out The Competitionfor your dream job with proven skills and certifications.Get started today Stand Outas the employee with proven skills.Start learning today for free Move Your Career Forwardwith certification training in the latest technologies.Start your trial today
Software Firewalls

From novice to tech pro — start learning today.