asked on

Event ID 50, 51, 57 \Device\Harddisk1 during a paging operation

While running a backup on a SBS 2003 I get an event ID 50, 51 and 57

Is my case the \Device\Harddisk1 is the USB backup drive. Does this mean the backup drive is failing?

Here are the full event ID details

Event Type:      Warning
Event Source:      Ftdisk
Event Category:      Disk
Event ID:      57
Date:            4/28/2010
Time:            11:00:10 PM
User:            N/A
Computer:      SERVER
Description:
The system failed to flush data to the transaction log. Corruption may occur.
------------------------------------------------------------------------------------------------------------
Event Type:      Warning
Event Source:      Disk
Event Category:      None
Event ID:      51
Date:            4/28/2010
Time:            11:00:07 PM
User:            N/A
Computer:      SERVER
Description:
An error was detected on device \Device\Harddisk1 during a paging operation.
----------------------------------------------------------------------------------------------------
Event Type:      Warning
Event Source:      Ftdisk
Event Category:      Disk
Event ID:      57
Date:            4/28/2010
Time:            11:00:07 PM
User:            N/A
Computer:      SERVER
Description:
The system failed to flush data to the transaction log. Corruption may occur.

Gerhardpet

ASKER

Sorry I posted Event ID 57 twice

Here is the log for Event ID 50

Event Type:      Warning
Event Source:      Ntfs
Event Category:      None
Event ID:      50
Date:            4/28/2010
Time:            11:00:07 PM
User:            N/A
Computer:      SERVER
Description:
{Delayed Write Failed} Windows was unable to save all the data for the file . The data has been lost. This error may be caused by a failure of your computer hardware or network connection. Please try to save this file elsewhere.

ASKER CERTIFIED SOLUTION

2Cs

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

Gerhardpet

ASKER

The backup software is EMC Retrospect

2Cs

Is there a paging file on this USB drive?

Does the backup report as being complete in the console? If so attach the report.

Al

Gerhardpet

ASKER

Where do I check if the drive has a paging file on the drive?

The backup reports as complete

SOLUTION

2Cs

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

Gerhardpet

ASKER

There is no paging file for the backup drive....
I can do a full restore with no errors but I still keep on getting Event ID's 51 and 57

Event Type:      Warning
Event Source:      Ftdisk
Event Category:      Disk
Event ID:      57
Date:            4/28/2010
Time:            11:00:09 PM
User:            N/A
Computer:      SERVER
Description:
The system failed to flush data to the transaction log. Corruption may occur.

Gerhardpet

ASKER

From what I found out so far it is the USB port that is cousing this.

IT_Fanatic

I get error 51 and 57 and this happen on mondays around 930-10 pm. It says disk 3 and it said once disk 4. Dell ran every single test and said the server is good no issues. The problem is I dont have a disk 3 and 4. Nor do I have a disk 2. I have disk 0 and 1 which consist of 4 hard drives on a RAID 5. I am running Acronis for backup software and I think this error comes when it run a full backup of my VM's but not when it does incrementals. Any idea on this?

Gerhardpet

ASKER

I ended up moving my backup USB drives over to another server so I never found a solution for this problem.

IT_Fanatic

I use a dell storage server

IT_Fanatic

Is this an issue that Acronis is causing and is it serious?