TheMetalicOne
asked on
Bridge WLAN and LAN on Sonicawall TZ100
So, By default out of the box the Sonicwall TZ 100 comes with separation between WLAN and LAN. I have figured out easily enough how to open it up so I can route back and forth between the subnets that are set by default (LAN 192.168.168.x and WLAN172.16.31.x )
I would like to merge the two so I have a single subnet of 172.16.31.0/24 so there is no routing needed between WLAN and LAN and one common gateway.
Any suggestions how this is done is appreciated. I was about to simply eliminate one of the subnets and just scope the DHCP for WLAN to issue IP's in a different part of the subnet, but I have a feeling it is more complex than that.
Thanks
I would like to merge the two so I have a single subnet of 172.16.31.0/24 so there is no routing needed between WLAN and LAN and one common gateway.
Any suggestions how this is done is appreciated. I was about to simply eliminate one of the subnets and just scope the DHCP for WLAN to issue IP's in a different part of the subnet, but I have a feeling it is more complex than that.
Thanks
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Oh, ok. I have not done much in the way of config so I will give that a go and report back.
ASKER
I did upgrade the firmware which added the ability to brdige the two together in the wizard, this option had not been avalailable on the older firmware. Now everything is on the same subnet and working great. Thanks
ASKER