Dell MD3000i setup question with multiple subnets

biffbyun
biffbyun used Ask the Experts™
on
Ok, so I'm setting up an MD3000i with two subets on two separate physical switches.  I have a Xenserver attaching to it if that matters.  My question is, how do I set the SAN up to failover to the other switch when one fails?  Is this done at the Xenserver?  
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
Top Expert 2014
Commented:
It doesn't really failover to a different switch if one fails, assuming you have logged into all 4 paths then if a switch fails it will fail over to one of the two remaining paths. See http://forums.citrix.com/thread.jspa?threadID=243883 for example.

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial