Why Experts Exchange?

Experts Exchange always has the answer, or at the least points me in the correct direction! It is like having another employee that is extremely experienced.

Jim Murphy
Programmer at Smart IT Solutions

When asked, what has been your best career decision?

Deciding to stick with EE.

Mohamed Asif
Technical Department Head

Being involved with EE helped me to grow personally and professionally.

Carl Webster
CTP, Sr Infrastructure Consultant
Ask ANY Question

Connect with Certified Experts to gain insight and support on specific technology challenges including:

Troubleshooting
Research
Professional Opinions
Ask a Question
Did You Know?

We've partnered with two important charities to provide clean water and computer science education to those who need it most. READ MORE

troubleshooting Question

How to make a Atmega128 programmable

Avatar of letharion
letharionFlag for Sweden asked on
HardwareNetworking Hardware-OtherEmbedded Hardware
4 Comments1 Solution495 ViewsLast Modified:
Recently a few STK600-Atmega128RFA1 http://www.atmel.com/dyn/products/tools_card.asp?tool_id=4677 was given to me. Now I'd like to experiment with getting a couple of LEDS hooked up to each, and have them communicate over zigbee.

I'm a programmer however, and now little about hardware beyond Desktop PCs. I recognize the 6 empty JTAG "slots" but know little of how to handle them. I assume I will need to buy more hardware to make it work.

So my question is this, what do I need to buy and read to get able to interface with the chip?
ASKER CERTIFIED SOLUTION
Avatar of David
DavidFlag of United States of America imagePresident
Commented:
This problem has been solved!
Unlock 1 Answer and 4 Comments.
See Answers