Solved

HP Procurve 2524 VLAN prioritization

Posted on 2010-08-12
2
669 Views
Last Modified: 2012-05-10
I have a two site configuration both have procurve 2524 switches and Cisco 1600 routers.  I am wondering if there is a good way to prioritize the voice traffic for the two ports that are doing the VOIP on each of the procurves.   Do I need to prioritize the traffic at the cisco level instead?
0
Comment
Question by:Dwci
2 Comments
 
LVL 13

Accepted Solution

by:
luc_roy earned 500 total points
Comment Utility
Do you have the vlans configured and working properly?  If so you would do this in the cisco router.  I would reccomend using QOS to do this task.  Here is a great guide on how to do that.

http://articles.techrepublic.com.com/5100-10878_11-6136216.html

it's for an 800 router but it will provide a good config for your 1600, you will just need to tweak it a bit when you put it in your router.
0
 

Author Comment

by:Dwci
Comment Utility
I am currently out of the office today, I will try and get to it later in the weekend.
0

Featured Post

How your wiki can always stay up-to-date

Quip doubles as a “living” wiki and a project management tool that evolves with your organization. As you finish projects in Quip, the work remains, easily accessible to all team members, new and old.
- Increase transparency
- Onboard new hires faster
- Access from mobile/offline

Join & Write a Comment

Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

771 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

12 Experts available now in Live!

Get 1:1 Help Now