Solved

Remote access terminal requiring local authentication before remote authentication

Posted on 2010-08-12
1
452 Views
Last Modified: 2012-05-10
I've setup a NM-16A terminal access module in a router and I am able to connect to the hosts using "telnet 192.168.1.1 2035" where the IP is the loopback address which will provide a telnet connection to a host. The problem is I have to authenticate against the terminal host first and then the remote host. I'm assuming this is because I have local AAA setup along with transport input SSH in order to allow users to SSH. Any recommendations on how to avoid authenticating locally before the remote device?

I used the following two guides to setup the terminal access server:

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_configuration_example09186a008014f8e7.shtml
http://www.velocityreviews.com/forums/t33288-cisco-2610-nm-32a-module-help.html


line con 0
line 33 48
session-timeout 20
exec-timeout 15 0
no exec
transport input all
flowcontrol hardware
line aux 0
line vty 0 4
password 7 234989sdjoisdf
transport input ssh
line vty 5 903
transport input ssh

Open in new window

0
Comment
Question by:adamshields
1 Comment
 
LVL 3

Accepted Solution

by:
adamshields earned 0 total points
ID: 33426234
I found the answer here: http://networking-forum.com/viewtopic.php?f=36&t=15046

Had to add:

[code]
aaa authentication login nologin none

line tty 33 48
login authentication nologin
[/code]

This allows the reverse telnet to work correctly.
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

Suggested Solutions

I have seen some questions on problems with SSH/telnet access to Cisco routers that may occur despite the fact that from a PC connected to your LAN, Internet connectivity is in place and users can access Internet sites without any issues.  There are…
Remote Desktop Shadowing often has a lot of benefits. When helping end users determine problems, it is much easier to see what is going on, what is being slecected and what is being clicked on. While the industry has many products to help with this,…
How to install and configure Citrix XenApp 6.5 - Part 1. In this video tutorial we have explained step by step installation of Citrix XenApp 6.5 Server on Windows Server 2008 R2 is explained in this video. We have explained the difference between…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

747 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

10 Experts available now in Live!

Get 1:1 Help Now