ie0
asked on
Windows 2003 ASR Restore with Raid Controller Driver
I have a windows 2003 with an ASR restore diskette and a windows backup on a USB drive.
The backup ws done using the Windows Backup utility.
I have to restore to the same server but a new array with larger hard drives.
I have a array controller with Raid 1 created.
When I boot from the Windows 2003 CD and do F2 and F6 for the ASR and specific SCSI driver, I get the message "insufficient disk space"
Up to this pointthe screens do not display my Raid 1 that has been set up from the ACU.
I get this message even before plugging in the USB drive, (so I assume it doesn't know how large my backup file is)
My backup file is 10GB, my Raid 1 is 500GB.
Thank you.
The backup ws done using the Windows Backup utility.
I have to restore to the same server but a new array with larger hard drives.
I have a array controller with Raid 1 created.
When I boot from the Windows 2003 CD and do F2 and F6 for the ASR and specific SCSI driver, I get the message "insufficient disk space"
Up to this pointthe screens do not display my Raid 1 that has been set up from the ACU.
I get this message even before plugging in the USB drive, (so I assume it doesn't know how large my backup file is)
My backup file is 10GB, my Raid 1 is 500GB.
Thank you.
ASKER
Hydrokid,
I have done this.
Downloaded the scsi driver to a diskette.
Booted from Windows CD - F6 ( SCSI driver) - F2 (ASR) - Put in SCSI drivers diskette - Put in ASR
I have done this.
Downloaded the scsi driver to a diskette.
Booted from Windows CD - F6 ( SCSI driver) - F2 (ASR) - Put in SCSI drivers diskette - Put in ASR
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
After this then use your ASR.