skywalker101
asked on
Sub Interfaces on Nokia/IP Appliance
Hi,
I want to be able to create sub interfaces on CP, Please look at the steps below is this correct ?
On the Checkpoint via Voyager under the interface tab create vlan 2 with an IP on the same subnet as the server
Interface 1 on the sw direct connection to the Fw, Interface 2 on switch add the server port in Vlan 2
Switch config
Cisco switch
int fa0/1
Switchport mode trunk
encap dot1q
I want to be able to create sub interfaces on CP, Please look at the steps below is this correct ?
On the Checkpoint via Voyager under the interface tab create vlan 2 with an IP on the same subnet as the server
Interface 1 on the sw direct connection to the Fw, Interface 2 on switch add the server port in Vlan 2
Switch config
Cisco switch
int fa0/1
Switchport mode trunk
encap dot1q
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.