Solved

PRTG Network Monitor notifications

Posted on 2010-08-23
1
782 Views
Last Modified: 2012-05-10
hi Experts,
i have purchased PRTG Network Monitor and im configuring notification for each group/device.

what would be you recommendation for the following triggers so i wont be SPAMMED with notifications.?

•State Triggers: Trigger a notification when a sensor enters an UP, DOWN, WARNING or UNUSUAL state. For state triggers, there are also escalation notifications available
.
•Speed Triggers: Trigger a notifications when a traffic sensor reaches a certain bandwidth limit for a specified time.

•Volume Triggers: Trigger a notification when a traffic sensor has reached a certain volume limit in a specified time.

•Threshold Triggers: Trigger out notifications when certain values are measured by a sensor.

•Change Triggers: Change triggers are triggered by some sensors whenever the content of a file or the event log has changed.


Thanks
0
Comment
Question by:aucklandnz
1 Comment
 
LVL 63

Accepted Solution

by:
SysExpert earned 500 total points
ID: 33511223
You are going to have to play a little. since this is device and network dependent.

All triggers may not be the same for each sensor, so first start with what seems logical for your needs for alerts and tweak as needed.

I hope this helps !
0

Featured Post

Better Security Awareness With Threat Intelligence

See how one of the leading financial services organizations uses Recorded Future as part of a holistic threat intelligence program to promote security awareness and proactively and efficiently identify threats.

Join & Write a Comment

Suggested Solutions

If you're not part of the solution, you're part of the problem.   Tips on how to secure IoT devices, even the dumbest ones, so they can't be used as part of a DDoS botnet.  Use PRTG Network Monitor as one of the building blocks, to detect unusual…
PRTG Network Monitor lets you monitor your bandwidth usage, so you know who is using up your bandwidth, and what they're using it for.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
This video gives you a great overview about bandwidth monitoring with SNMP and WMI with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're looking for how to monitor bandwidth using netflow or packet s…

747 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

12 Experts available now in Live!

Get 1:1 Help Now