Solved

cisco c6500 switching bus 3 second stall post line card removal

Posted on 2010-08-24
3
2,261 Views
Last Modified: 2012-05-10
Has anyone experienced a switching bus stall for 3 seconds post shutting down a line card – interfaces and power:

%C6KERRDETECT-SP-2-SWBUSSTALL: The switching bus is experiencing stall for 3 seconds
%C6KPWR-SP-4-DISABLED: power to module in slot 1 set off (admin request)
%OIR-SP-6-REMCARD: Card removed from slot 1, interfaces disabled
%C6KERRDETECT-SP-2-SWBUSSTALL: The switching bus is experiencing stall for 3 seconds
0
Comment
Question by:stuafle1
  • 2
3 Comments
 
LVL 28

Accepted Solution

by:
mikebernhardt earned 500 total points
ID: 33559744
No, but since you were removing a card or shutting it down, I wouldn't worry about it TOO much. Do you have CCO access? You can look in the bug tool to see if there's something there.
0
 

Author Comment

by:stuafle1
ID: 33563303
It is a design feature - to maintian bus integrity during module [line card] install.
0
 

Author Closing Comment

by:stuafle1
ID: 33713146
Design feature
0

Featured Post

VMware Disaster Recovery and Data Protection

In this expert guide, you’ll learn about the components of a Modern Data Center. You will use cases for the value-added capabilities of Veeam®, including combining backup and replication for VMware disaster recovery and using replication for data center migration.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Managing 24/7 IT Operations is a hands-on job and indeed a difficult one. Over the years I have found some simple tips and techniques to increase the efficiency of the overall operations. The core concept has always been on continuous improvement; a…
There are times where you would like to have access to information that is only available from a different network. This network could be down the hall, or across country. If each of the network sites have access to the internet, you can create a ne…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Here's a very brief overview of the methods PRTG Network Monitor (https://www.paessler.com/prtg) offers for monitoring bandwidth, to help you decide which methods you´d like to investigate in more detail.  The methods are covered in more detail in o…

785 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question