Solved

HP ProCurve 2910al-24G VLAN configuration issues\questions

Posted on 2010-08-25
1
1,642 Views
Last Modified: 2012-05-10
Howdy,
We have a new 2910al-24g that I am attempting to get up and running. The plan is to break up the ports into several VLANs, that are all unable to communicate with each other, but can reach the primary vlan which will feed into our internet router (Untangle). Since the internet router does not handle VLANs well I want the routing to be handled by the switch.
I have never setup VLANs on an HP before (only a couple times on Cisco) and am running into a couple issues.
1. Devices on the different vlans can ping the static IPs of the different vlans. If possible I would like to prevent all traffic completely unless it is going to the primary vlan to reach the router.
2. From all VLANs (except the primary) I cannot ping the static IP assigned to the primary vlan (10.254.254.253).

I have attached the config if anyone could assist or point me in the right direction.

Thanks!
Alan
HP-Switch.txt
0
Comment
Question by:aiscom
1 Comment
 

Accepted Solution

by:
aiscom earned 0 total points
ID: 33546854
Nevermind, I was able to figure out the ACLs needed to get this working.
0

Featured Post

Netscaler Common Configuration How To guides

If you use NetScaler you will want to see these guides. The NetScaler How To Guides show administrators how to get NetScaler up and configured by providing instructions for common scenarios and some not so common ones.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Sharing same loopback address on different switches 1 48
Stacked switch question 7 40
Internet link load balancer 6 67
tamper proof asset tags - benefits 4 25
When it comes to security, there are always trade-offs between security and convenience/ease of administration. This article examines some of the main pros and cons of using key authentication vs password authentication for hosting an SFTP server.
In this article, I am going to show you how to simulate a multi-site Lab environment on a single Hyper-V host. I use this method successfully in my own lab to simulate three fully routed global AD Sites on a Windows 10 Hyper-V host.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

856 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question