execborbor
asked on
NCP Client connecting to Juniper
I am trying to configure the NCP secure client to connect to Juniper device via L2TP over IPSEC. Has anyone successfully done this - if so can you please provide a step by step guide on how to accomplish this task?
The client is a pure IPsec client. You can't use it with L2TP. I suggest you contact NCP Technical Support. Email them at helpdesk@ncp-e.com or give them a call. They will help you to figure out what to do.
Even if this would be a L2TP/IPSec connection, that combination is a PITA with Juniper devices.
Have you read http://kb.juniper.net/KB17364 yet?
ASKER
Thanks Allvirtual, I shall contact technical support and see what they have to say. Qlemo - thanks for the link, however, juniper's site is undergoing maintenance at the moment and I could not read the document. I shall try reading doc later and let you know.
I'm able to access that page - after I log in.
ASKER
Issue resolved by literature from NCP
Objection: Please either give more details (which grants an accept of your own findings), or delete the question. As-is, the question doesn't have any value to retain in the knowledgebase.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Thanks for sharing that. You might want to accept your last post then.
ASKER
Issue resolved based on NCP documentation