Solved

using SDM with GNS 3

Posted on 2010-08-29
3
619 Views
Last Modified: 2012-05-10
I have created a loopback interface on my PC 10.100.100.50./24 with the DG 10.100.100.1.
On the GNS 3 I have a router on which I have configured the interface with IP address of 10.100.100.1/24

from the PC I can't ping the 10.100.100.1 and from the router I can't ping 10.100.100.50

any help ?

thanks
0
Comment
Question by:jskfan
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
3 Comments
 
LVL 24

Expert Comment

by:rfc1180
ID: 33553076
What is your OS?
0
 

Accepted Solution

by:
jskfan earned 0 total points
ID: 33553123
0
 
LVL 4

Expert Comment

by:Muhammed-Rummaneh
ID: 33594465

Dear jskfan

before a month , i have the same problem ....and i looked for solution to do solve my problem and i found this link

this link will give step by step to do this ( SDM using GNS3 ) ....it is vedio file

http://www.gns3-labs.com/2008/07/10/video-configure-sdm-in-gns3/


Good Luck
0

Featured Post

Enroll in May's Course of the Month

May’s Course of the Month is now available! Experts Exchange’s Premium Members and Team Accounts have access to a complimentary course each month as part of their membership—an extra way to increase training and boost professional development.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

This article is a guide to configure bridging on Cisco Routers.  This is something I never knew was possible until after making a few phone calls to Cisco.  Using bridging saved our company money by not requiring us to purchase a new switch.  Bridgi…
Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

734 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question