Solved

How to check the channelized t1 interface type remotely?

Posted on 2010-08-30
2
332 Views
Last Modified: 2012-05-10
Hi guy,

As the title, how can I check the channelized t1 interface type remotely?

I have tried "show inventory", but seems the IOS is not supported for this command... the router model is 7206VXR

Thanks
0
Comment
Question by:gcl_hk
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 15

Accepted Solution

by:
bkepford earned 500 total points
ID: 33558570
Try the show controller command.
0
 
LVL 6

Author Closing Comment

by:gcl_hk
ID: 33659462
This solves all or part of my problem.
0

Featured Post

Industry Leaders: We Want Your Opinion!

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Cisco ASA 5512-X Active/Standby HA 4 50
Router Question 12 88
Tracert fails final hop at some client offices 3 49
Multicast IGMP Join Group 8 56
While it is possible to put two routes in place with the secondary having a higher metric, this may not always work. In the event of a failure that does not bring down the physical interface on the router the primary route is not removed. There is a…
It happens many times that access list (ACL) have to be applied to outgoing router interface in order to limit some traffic.This article is about how to test ACL from the router which is not very intuitive for everyone. Below scenario shows simple s…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

751 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question