Solved

Cisco ASA 5510 how do I remove a specific tunnel-group I created that is not working and leave the others intact.

Posted on 2010-08-30
1
868 Views
Last Modified: 2012-05-10
The preshared key I created is not working when I try to test connect as the vpn user with the preshared key I created. I want to start over and try again, but I do not want to remove the other existing and important tunnel-groups. What is the command syntax to remove a VPN user or a tunnel-group if that is the more accurate request. It would actually be preferable to be able to change or edit or replace the preshared key and leave the remainder of the config intact, but if that is not possible then I would like the syntax to remove the group so I can try again. If you want to be really helpful you can also paste in the syntax to create a new tunnel-group correctly in the event I made an error. I used the deprecated command from the 501 series, but it did add it and so I thought it would work, but the client log indicates an incorrect key.

Thank you,

Christa
0
Comment
Question by:I_S_F_C_O
1 Comment
 
LVL 17

Accepted Solution

by:
Kvistofta earned 125 total points
ID: 33564310
clear configure tunnel-group 123.123.123.123

clear configure username john
0

Featured Post

Portable, direct connect server access

The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Like many others, when I created a Windows 2008 RRAS VPN server, I connected via PPTP, and still do, but there are problems that can arise from solely using PPTP.  One particular problem was that the CFO of the company used a Virgin Broadband Wirele…
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Windows 10 is mostly good. However the one thing that annoys me is how many clicks you have to do to dial a VPN connection. You have to go to settings from the start menu, (2 clicks), Network and Internet (1 click), Click VPN (another click) then fi…

856 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question