Solved

Email Relay in Exchange 2010

Posted on 2010-08-31
3
1,504 Views
Last Modified: 2012-05-10
What is the best way to setup email relay in Exchange 2010 to resolve the 2 scenarios below

Scenario 1
Multiple Linux boxes using sendmail send alert messages to recipients in Exchange. These Linux boxes are located within the LAN and have the same I.P Address range as the exchange 2010 server. They are not members of the Domain. Currently in our 2003 exchange environment they are just given relay permission.

Scenario 2
Server that is part of the domain encrypts messages and sends them to the exchange server to be relayed to email addresses outside the company. Server uses POP3 Virtual Server in current 2003 environment and again is configured to relay

Any help would be greatly appreciated. Steps using EMC or EMS will be both be acceptable.

Thanks in advance
0
Comment
Question by:PACSAdmin
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
3 Comments
 
LVL 34

Assisted Solution

by:Shreedhar Ette
Shreedhar Ette earned 200 total points
ID: 33573276
0
 
LVL 6

Author Comment

by:PACSAdmin
ID: 33573298
Dematzers article is for sending from one domain to another where i want to send to the world in scenario 2. Steven bradbury suggestion could work for scenario however i have read other articles that say to do this you need to configor an additional I.P Address on the server which i could do but prefer not to. Has anyone used the steps in the second article with success
0
 
LVL 11

Accepted Solution

by:
JuusoConnecta earned 300 total points
ID: 33575052
Create Receive Connectors under Server Configuration  -> Hub Transport -> New Receive Connector ->

Scenario 2 -> FQDN of exchange 2010 Server -> Add the ip addresses of the nodes that needs relay thru ex2010 -> set authentication to "Transport Layer Security (TLS)" and "Basic Authentication" -> Permission Groups, Anynymous and

Scenario 1 -> FQDN of exchange 2010 Server -> add the ip addresses if the nodes to relay thru ex2010 (also add local ip addresses to receive mail "All available IPv4, port 587", the other one with port 25 should have been added by default) -> set authentication to "Transport Layer Security (TLS)" and "Basic Authentication with offer baisc authenication only after starting TLS" -> Permission Groups Anonymous
0

Featured Post

Enterprise Mobility and BYOD For Dummies

Like “For Dummies” books, you can read this in whatever order you choose and learn about mobility and BYOD; and how to put a competitive mobile infrastructure in place. Developed for SMBs and large enterprises alike, you will find helpful use cases, planning, and implementation.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

This article lists the top 5 free OST to PST Converter Tools. These tools save a lot of time for users when they want to convert OST to PST after their exchange server is no longer available or some other critical issue with exchange server or impor…
This article describes my battle tested process for setting up delegation. I use this process anywhere that I need to setup delegation. In the article I will show how it applies to Active Directory
This tutorial will walk an individual through the process of transferring the five major, necessary Active Directory Roles, commonly referred to as the FSMO roles to another domain controller. Log onto the new domain controller with a user account t…
This tutorial will walk an individual through setting the global and backup job media overwrite and protection periods in Backup Exec 2012. Log onto the Backup Exec Central Administration Server. Examine the services. If all or most of them are stop…

740 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question