• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 840
  • Last Modified:

Is 1FE-TX Card Workable In Cisco 2811 Router

I recently installed a 1FE-TX card into the above mentioned router, but it does not indicate an additional interface a POST is done on the router. The Link and 100 Mbps Led lits. I need another fast ethernet on the router for mobile connectivity. Can an expert assist with a solution.
0
stewie_don
Asked:
stewie_don
1 Solution
 
Jody LemoineNetwork ArchitectCommented:
Unfortunately, that's not going to do the trick for you.  The NM-1FE-TX module was at end-of-life when the 2811 came out and it isn't supported by the platform.  Supported interfaces and modules for that unit are here:

http://www.cisco.com/en/US/products/ps5854/products_relevant_interfaces_and_modules.html

Putting any of the following in the unit will give you what you need though.

HWIC-1FE
HWIC-2FE
0
 
stewie_donAuthor Commented:
Thanks Jody I will keep you posted after purchasing a HWIC-2FE.
0

Featured Post

Free Tool: Subnet Calculator

The subnet calculator helps you design networks by taking an IP address and network mask and returning information such as network, broadcast address, and host range.

One of a set of tools we're offering as a way of saying thank you for being a part of the community.

Tackle projects and never again get stuck behind a technical roadblock.
Join Now