Solved

Cisco 1811

Posted on 2010-09-18
6
572 Views
Last Modified: 2012-05-10
I have 2 sites connected with 2 microwave links , each link gives its output as ethernet port .
How can i make the cisco routers on the sties aggregate the 2 links and deal with them as one link.

I use Cisco 1811 router on both sides.
0
Comment
Question by:aeissa
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
6 Comments
 
LVL 3

Expert Comment

by:kf4zmt
ID: 33709093
Have you considered using EtherChannel?  I've never used an EtherChannel for anything other than a LAN environment.  It might work in your circumstance.  Don't know.
0
 
LVL 79

Expert Comment

by:lrmoore
ID: 33709103
Simply use equal cost routing across both links. Enable IP CEF and use per-packet load-balancing.
0
 
LVL 1

Accepted Solution

by:
rivira earned 500 total points
ID: 33709108
0
Simple, centralized multimedia control

Watch and learn to see how ATEN provided an easy and effective way for three jointly-owned pubs to control the 60 televisions located across their three venues utilizing the ATEN Control System, Modular Matrix Switch and HDBaseT extenders.

 
LVL 79

Expert Comment

by:lrmoore
ID: 33709120
Here's a document for load-balancing over parallel routes with CEF
http://www.cisco.com/en/US/products/hw/modules/ps2033/prod_technical_reference09186a00800afeb7.html
0
 
LVL 24

Expert Comment

by:rfc1180
ID: 33709122
>How can i make the cisco routers on the sties aggregate the 2 links and deal with them as one link.
you can't, not with the 1811.

Billy
0
 

Expert Comment

by:vihunter
ID: 33717341
Billy is right for the most part.  1800s especially with the Ethernet ports on the WAN side is a bit tricky.  Only thing I can remotely think of is cisco OER protocol (might have different name now).
0

Featured Post

Major Incident Management Communications

Major incidents and IT service outages cost companies millions. Often the solution to minimizing damage is automated communication. Find out more in our Major Incident Management Communications infographic.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

It happens many times that access list (ACL) have to be applied to outgoing router interface in order to limit some traffic.This article is about how to test ACL from the router which is not very intuitive for everyone. Below scenario shows simple s…
This article is a guide to configure bridging on Cisco Routers.  This is something I never knew was possible until after making a few phone calls to Cisco.  Using bridging saved our company money by not requiring us to purchase a new switch.  Bridgi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

752 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question