dkuras
asked on
Mazatrol 640T CNC Controller
I have a MAZAK QT-30 Lathe controlled by a Mazatrol 640T controller running Mazatrol's "FUSION" application over a WIN95 OS (it's an old machine). The 640T supports networking via a PCMCIA card interface. I've installed WIN95 TCP/IP networking and PCMCIA card services and mapped a directory from our servers. This works fine on the WIN95 part of the controller. I can see and open the mapped drive without difficulty. Problem is the FUSION software does not see that drive even after given the complete drive path. I've gone through MAZAK support, but have not gotten any of their fixes to work. I realize that this is not the usual type of question seen in this forum, but I'm running out of ideas.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
config.sys
FILESHIGH=255
LASTDRIVEHIGH=Z
DOS=HIGH,UMB
Winsock connections use file handles
Around 30 is used by windows
And each ftp session uses 2 connections, so you will need to limit your FTP server to max 100 sessions
if you run out of file handles your system freezes and/or bluescreens