Solved

Cisco PIX 506E working with a cisco wrvs4400 wireless

Posted on 2010-09-24
2
294 Views
Last Modified: 2013-12-27
I have to setup a cisco wrvs4400 wireless to work with a Cisco PIX 506E firewall.
Is their any special parameters that need to be done.

I am only setting this up for wirless
0
Comment
Question by:Jschnapp
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 28

Accepted Solution

by:
bgoering earned 500 total points
ID: 33760541
I wouldn't expect any special parms will be required. Just add the acls for what you are allowing to and from the wrvs to the pix. If you wireless clients will be on a different subnet you will need to add a route statement for that - then you should be good to go.

If this doesn't fully answer your question please provide more information. Whee will the wrvs be deployed relative to the pix?  inside device? dmz device? etc.
0
 

Author Closing Comment

by:Jschnapp
ID: 33997558
Solved!
0

Featured Post

Manage your data center from practically anywhere

The KN8164V features HD resolution of 1920 x 1200, FIPS 140-2 with level 1 security standards and virtual media transmissions at twice the speed. Built for reliability, the KN series provides local console and remote over IP access, ensuring 24/7 availability to all servers.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

This article is a step by step guide on how to create a basic PTP link using Ubiquiti airOS devices. This guide can be used on the following Ubiquiti AirMAX devices. Nanostation, Bullets, AirBridge, Nanobeam, NanoBridge to name a few. Please review …
This paper addresses the security of Sennheiser DECT Contact Center and Office (CC&O) headsets. It describes the DECT security chain comprised of “Pairing”, “Per Call Authentication” and “Encryption”, which are all part of the standard DECT protocol.
Viewers will learn how to connect to a wireless network using the network security key. They will also learn how to access the IP address and DNS server for connections that must be done manually. After setting up a router, find the network security…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

729 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question