aduffield76
asked on
I need to set up a site-to-site VPN on 2 Cisco 1801 routers. Does anyone have a good step-by-step guide that I can use?
I have 2 separate sites, both with Cisco 1801 Routers.
I need to set up a site to site VPN between the 2 sites.
Do both ends of the VPN need to be on separate subnets? I assume yes do prevent clashes.
Does anyone have any sites or guides that can help me?
I need to set up a site to site VPN between the 2 sites.
Do both ends of the VPN need to be on separate subnets? I assume yes do prevent clashes.
Does anyone have any sites or guides that can help me?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Please refer this guide howto do L2L vpn:
http://www.networkstraining.com/lan-to-lan-ipsec-vpn-between-two-cisco-routers/
If you want to use same subnet on booth sides please configure L2TPv3:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120s/120s23/l2tpv3.htm
Best regards,
Istvan