VLAN HP Procurve 2510G-24

Mr_OCD
Mr_OCD used Ask the Experts™
on
I've been given a brand new HP Procurve 2510G-24 (1gb ports) to configure... basically I have been asked to configure ports 1-12 for one IP subnet and 13-24 for another so that they cannot talk to each other.

Is this possible with this switch and if so how do I do it?

500 points as need quick answer!
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
HP ProCurve Switch # enable
HP ProCurve Switch # config term
HP ProCurve Switch (config)# ip routing
HP ProCurve Switch (config)# router rip
HP ProCurve Switch (rip)# vlan 100
HP ProCurve Switch (vlan-100)# untag a1-a24
HP ProCurve Switch (vlan-100)# tag b1
HP ProCurve Switch (vlan-100)# ip address 10.10.100.1/24
HP ProCurve Switch (vlan-100)# ip rip v2-only
HP ProCurve Switch (vlan-100)# vlan 200
HP ProCurve Switch (vlan-200)# untag c1-c24
HP ProCurve Switch (vlan-200)# tag b1
HP ProCurve Switch (vlan-200)# ip address 10.10.200.1/24
HP ProCurve Switch (vlan-200)# ip rip v2-only
HP ProCurve Switch (vlan-200)# write mem


*****************but this is possible in hp 2910 AL not in 2510G-24...because 2510G-24 is a L2 switch. inter vlan routing only support in L3 switch.
the above one is an example of configuration from one website.

Author

Commented:
Basically the plan is to basically seperate the single switch into two seperate lans to save buying a second switch... each vlan will have its own DHCP router connected to it.
Commented:
Sussed it ... used the CLi in the end to create new VLAN then set the ports and IP Config for each VLAN ... that should do it.

Author

Commented:
Correct solution for this switch and tested as working.

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial