HMC connection to IBM POWER5

RNH4
RNH4 used Ask the Experts™
on
having difficulty in connecting a 7315-CR3 to a p650  ( 7038-6M2).
this older style does not have HMC ethernet ports only SERIAL HMC ports.
How do you make good connection?
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
Most Valuable Expert 2013
Top Expert 2013
Commented:
See chapter 2.8.1 of this guide:
http://www.redbooks.ibm.com/redpapers/pdfs/redp0194.pdf

wmp

Author

Commented:
did not have an HMC with LOW enough firmware, nor proper cabling. Thanks

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial