Cisco Pix 506e static NAT

jtforde518
jtforde518 used Ask the Experts™
on
I have a client with a Cisco Pix 506e.
they currently have a static NAT for RDP (3389) from their outside IP address to an inside IP address.
like this: static (inside,outside) tcp 74.xxx.xxx.14 3389 192.168.1.6 3389 netmask 255.255.255.255 0 0

Is it possible for me to add a static NAT like this one to route traffic on a different port like 40500 from the outside IP address to port 3389 on a different inside IP address? Like this?
static (inside,outside) tcp 74.xxx.xxx.14 40500 192.168.1.3 3389 netmask 255.255.255.255 0 0
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
Sure, as long as there isn't a conflicting static NAT for the entire 74.xxx.xxx.14 IP or a conflicting source port (can't use 40500 for more than one forwarding rule).

Author

Commented:
@stsonline, thanks and no they only have the one static NAT at the top of my post for port 3389 from the outside IP to the 192.168.1.6 IP
What I was hoping to be able to do is have a means of using RDP from outside using an unassigned IP port number to connect from that port on the outside address to port 3389 on a different inside IP address, 192.168.1.3
If it would work this would allow access to two different terminal servers from outside.
Yep, should work fine.

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial