asked on Regarding printer problem of falling asleep
Hello everybody,
The status of one printer in our company with model “HP LaserJet P3005dn”, goes to “Insluimermodus” (sleeping mode) after every few minutes. And then the printer doesn’t react at all. We always need to restart the printer to make it work and then again after few minutes it goes to “insluimermodus”(sleep mode).
Can anyone please suggest me some reason behind it or how can I solve it ?
Thanx a lot in advance
The status of one printer in our company with model “HP LaserJet P3005dn”, goes to “Insluimermodus” (sleeping mode) after every few minutes. And then the printer doesn’t react at all. We always need to restart the printer to make it work and then again after few minutes it goes to “insluimermodus”(sleep mode).
Can anyone please suggest me some reason behind it or how can I solve it ?
Thanx a lot in advance
OutlookPrinters and Scanners
Last Comment
John_BAS
ASKER CERTIFIED SOLUTION
THIS SOLUTION ONLY AVAILABLE TO MEMBERS.
View this solution by signing up for a free trial.
Members can start a 7-Day free trial and enjoy unlimited access to the platform.
Hi
Also you can try
On the control panel,
Configure device menu ->
Resets submenu ->
SLEEP MODE to OFF.
May this will help
Also you can try
On the control panel,
Configure device menu ->
Resets submenu ->
SLEEP MODE to OFF.
May this will help
ASKER
Hello Anupvs,
I am not a native dutch speaker and I am working in Netherlands on a dutch operating system. Can you please guide me in little more detail about where can i find the option "sleep mode"?
Thanx a lot
I am not a native dutch speaker and I am working in Netherlands on a dutch operating system. Can you please guide me in little more detail about where can i find the option "sleep mode"?
Thanx a lot
SOLUTION
THIS SOLUTION ONLY AVAILABLE TO MEMBERS.
View this solution by signing up for a free trial.
Members can start a 7-Day free trial and enjoy unlimited access to the platform.
ASKER
Thanx anupvs,
I have followed these steps, but in last step, instead of "sluimermodus", it was "Powersave". So i select "Uit" for it. I have rebooted the printer. I would just like to test it for few minutes and then i will update you with the result.
I have followed these steps, but in last step, instead of "sluimermodus", it was "Powersave". So i select "Uit" for it. I have rebooted the printer. I would just like to test it for few minutes and then i will update you with the result.
ASKER
The solution is great.
I have installed the suggested firmware. I would just like to test its performance for few minutes or an hour and will reply you back with the result.
Thanx again