<div>
Just to be sure, you're doing the following right?<br />
<br />
Router# clock set 10:48:05 November 9 2010<br />
Router# show clock detail<br />
Router# wr mem<br />

</div>


Just to be sure, you're doing the following right?

Router# clock set 10:48:05 November 9 2010
Router# show clock detail
Router# wr mem


<div>
To check it, do a &quot;show ntp status&quot; and see what it says.
</div>


To check it, do a "show ntp status" and see what it says.

<div>
<div class="content wysiwyg-content">
Hi Guys,<br />
<br />
I’m having a problem with the time on a 2960 switch always defaulting back to Mon March 1 1993. I have been using “clock set hh:mm:ss 9 November 2010” &nbsp;which changes the date/time however as soon as I do a reboot of the switch is reverts back (of course I “wr mem” after making the change to the clock)<br />
<br />
The timezone was set and is perfectly fine<br />
<br />
<br />
<br />

</div>
</div>


Hi Guys,

I’m having a problem with the time on a 2960 switch always defaulting back to Mon March 1 1993. I have been using “clock set hh:mm:ss 9 November 2010”  which changes the date/time however as soon as I do a reboot of the switch is reverts back (of course I “wr mem” after making the change to the clock)

The timezone was set and is perfectly fine





Time not defaulting after reboot on Cisco 2960 switch

A switch is a device that filters and forwards packets of data between LAN segments. Switches operate at the data link layer or the network layer of the Open Systems Interconnection (OSI) Reference Model and therefore support any packet protocol. LANs that use switches to join segments are called switched LANs or, in the case of Ethernet networks, switched Ethernet LANs. A hub is a connection point for devices in a network. Hubs are commonly used to connect segments of a LAN. A hub contains multiple ports; when a packet arrives at one port, it is copied to the other ports so that all segments of the LAN can see all packets.