[2 days left] What’s wrong with your cloud strategy? Learn why multicloud solutions matter with Nimble Storage.Register Now

x
?
Solved

How to apply access-list 102 cisco 2911

Posted on 2010-11-09
1
Medium Priority
?
1,112 Views
Last Modified: 2012-08-14
Hi there,
I am following this article:
http://www.cisco.com/en/US/products/ps5855/products_configuration_example09186a0080ac3082.shtml

I am stuch at these commands:
access-list 102 remark SDM_ACL Category=256
access-list 102 remark Outgoing Traffic
access-list 102 permit ip 10.10.10.0 0.0.0.255 10.77.241.0 0.0.0.255
access-list 102 remark Incoming Traffic
access-list 102 permit ip 10.77.241.0 0.0.0.255 10.10.10.0 0.0.0.255
!

Question:
My show run is attached.  In my case there is no access-list 102, how do I create it and which interface to apply and how, commands will be helpful.
Thanks
showrun2911EEpurposes.txt
0
Comment
Question by:amanzoor
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 5

Accepted Solution

by:
BooSTid earned 2000 total points
ID: 34097070
typing those commands from the terminal configuration prompt will create that access-list. Each time you use the command "access-list 102 ...." it adds an entry to the bottom of that particular access list. The big thing to keep in mind when creating access lists is that they are processed from the top to the bottom, and order of entry is very important.

To apply an access list to an interface; you go to the desired interface, and then use the command:

ip access-group xxx in/out

where xxx is the access list number (or name), and in/out (choose one) specifies the traffic direction to match (from that interface's perspective).
0

Featured Post

VIDEO: THE CONCERTO CLOUD FOR HEALTHCARE

Modern healthcare requires a modern cloud. View this brief video to understand how the Concerto Cloud for Healthcare can help your organization.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I have seen some questions on problems with SSH/telnet access to Cisco routers that may occur despite the fact that from a PC connected to your LAN, Internet connectivity is in place and users can access Internet sites without any issues.  There are…
Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

656 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question