Solved

Cisco 4948 How to remove unrouted vlan statement

Posted on 2010-11-12
1
1,291 Views
Last Modified: 2012-05-10
I would to remove the unrouted statement from the following:

interface GigabitEthernet1/25
 description Unrouted Vlan 100
 switchport access vlan 501
 switchport mode access
!
interface GigabitEthernet1/26
 description Unrouted Vlan 100
 switchport access vlan 501
!
interface GigabitEthernet1/27
 description Unrouted Vlan 100
 switchport access vlan 501
!
interface GigabitEthernet1/28
 description Unrouted Vlan 100
 switchport access vlan 501
!
interface GigabitEthernet1/29
 description Unrouted Vlan 100
 switchport access vlan 501
!
interface GigabitEthernet1/30
 description Unrouted Vlan 100
 switchport access vlan 501

any help would be appreciated please be specific like anable config t  ect.

Thanks
0
Comment
Question by:cp361
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 34

Accepted Solution

by:
Istvan Kalmar earned 125 total points
ID: 34124463
conf t
int ran giga 1/25 - 30
no des
CTRL+Z
write


but they are description, so irrelevant
0

Featured Post

Free Tool: Site Down Detector

Helpful to verify reports of your own downtime, or to double check a downed website you are trying to access.

One of a set of tools we are providing to everyone as a way of saying thank you for being a part of the community.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

734 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question