Solved

Watchguard Site to Site VPN Issues

Posted on 2010-11-15
3
720 Views
Last Modified: 2013-03-15
We have an X20e at IP at 192.168.20.1 and site to site VPN connections to 2 XTM 21 appliances at 10.0.1.1 and 10.0.10.1 respectively. The X20e can communicate with each appliance perfectly and the end points can communicate back. However the 2 X20e appliances cannot send traffic to each other.

What is the proper configuration to allow traffic?
0
Comment
Question by:tampatechman
  • 2
3 Comments
 
LVL 32

Expert Comment

by:dpk_wal
ID: 34142153
If you wish to allow traffic through x20e making it a central point of failure; this is called hub and spoke VPN; but in my opinion you would be better off configuring a tunnel from first XTM to second.

Please have a look at article below:
http://watchguard.custhelp.com/app/answers/detail/a_id/1272
(Read sections: Hub-and-spoke networks and Meshed networks)

Please advice if you need any help with configuration.

Thank you.
0
 

Accepted Solution

by:
tampatechman earned 0 total points
ID: 34144941
0
 

Author Closing Comment

by:tampatechman
ID: 34182371
found solution
0

Featured Post

Independent Software Vendors: We Want Your Opinion

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Juniper VPN devices are a popular alternative to using Cisco products. Last year I needed to set up an international site-to-site VPN over the Internet, but the client had high security requirements -- FIPS 140. What and Why of FIPS 140 Federa…
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Windows 10 is mostly good. However the one thing that annoys me is how many clicks you have to do to dial a VPN connection. You have to go to settings from the start menu, (2 clicks), Network and Internet (1 click), Click VPN (another click) then fi…

679 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question