Solved

Forcing RDP through specific WAN port of Draytek 3300V+

Posted on 2010-11-16
1
959 Views
Last Modified: 2012-05-10
OK - my first time ever with a load balancing product.

I have a Vigor 3300V+ with the following config:-

LAN IP - 10.0.0.2 / 255.255.255.0
WAN1 - 10.1.0.1 / 255.255.255.0
WAN2 - 10.2.0.1 / 255.255.255.0

WAN1 and WAN2 gateways are 10.1.0.2 and 10.2.0.2 respectively.

I need to dedicate WAN2 to outbound RDP only, and have WAN1 handle all other traffic.

I've looked at the load balancing policies, but to be honest, it's a bit over my head...

Does anyone have any experience with configuring these?
0
Comment
Question by:Chris Millard
1 Comment
 
LVL 5

Accepted Solution

by:
q2q earned 500 total points
ID: 34156645
On the load balancing policy (network > load balance policy)
create a new policy

set protocal to tc
set all source and dest ips and subnets as 0.0.0.0 / 0.0.0.0
destination port range set it to 3389 - 3389,
set the wan to 2

then WAn (network > wan)
enable load balance tick load balance on wan 1 and wan 2 and set weight

wan1 90%
wan2 10%

0

Featured Post

Netscaler Common Configuration How To guides

If you use NetScaler you will want to see these guides. The NetScaler How To Guides show administrators how to get NetScaler up and configured by providing instructions for common scenarios and some not so common ones.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

In the hope of saving someone else's sanity... About a year ago we bought a Cisco 1921 router with two ADSL/VDSL EHWIC cards to load balance local network traffic over the two broadband lines we have, but we couldn't get the routing to work consi…
When you try to share a printer , you may receive one of the following error messages. Error message when you use the Add Printer Wizard to share a printer: Windows could not share your printer. Operation could not be completed (Error 0x000006…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

861 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

19 Experts available now in Live!

Get 1:1 Help Now