Solved

Device Manager image set, but unable to find disk0:/ asdm-508.bin

Posted on 2010-11-16
1
2,271 Views
Last Modified: 2012-05-10
ASA 5510
Help!! I upgraded asdm-508.bin to asdm-631.bin and now cannot get in to the device. Using the asdm launcher this error populates: "The device x.x.x.x does not have the appropriate device manager image installed". I can however, use putty to access the device. How can I gain access to the asdm via web browser??? Have I tanked the asdm?
0
Comment
Question by:stowyo
1 Comment
 
LVL 10

Accepted Solution

by:
cstosgale earned 250 total points
ID: 34150036
You will probably also need to upgrade the image as well. It is likely the version you are on doesn't support asdm 6.31. This usually requires ASA version 8 or above.

In order to get ASDM back, roll back to the old image. To do this, reload the ASA if you didn't save the config, or get to the command line and enter:-

conf t
asdm image flash:asdm-508.bin

I wouldn't upgrade the image unless you know what you are doing as there are a number of considerations when upgrading to later versions of 8.
0

Featured Post

Netscaler Common Configuration How To guides

If you use NetScaler you will want to see these guides. The NetScaler How To Guides show administrators how to get NetScaler up and configured by providing instructions for common scenarios and some not so common ones.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

One of the Top 10  common Cisco VPN problems are not-matching shared keys. This is an easy one to fix, but not always easy to notice, see the case below. A simple IPsec tunnel between fast Ethernet interfaces of routers SW1 (f1/1) and R1(f0/0). …
Sometimes, you want your microsoft VPN to route all the traffic to the remote network. Usually your employer network. This makes it possible to access all the nodes inside this remote LAN, even if they have no "public DNS" entries. To do so, you wo…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

911 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

20 Experts available now in Live!

Get 1:1 Help Now