Is it possible to configure Cisco SR520-FE with multiple public IP numbers using static nat

I was hoping to assign an unused IP address from my ISP to a private IP address inside on a new server. I don't see any options in CCA to do this and I was wondering if it was possible using the CLI. I hoped to get some basic feedback before attempting it since it's currently in use.

Thanks in advance.
sgentryAsked:
Who is Participating?
 
Jody LemoineConnect With a Mentor Network ArchitectCommented:
If you're trying to for ward 80/tcp from the outside to the inside, you should be using an "ip nat inside source static" for both.  You don't *need* an ACL fir either, but if you have ACLs or firewall rules governing your Internet-facing interfaces, you'll need to alter those to accommodate the new NAT statements.
0
 
Jody LemoineNetwork ArchitectCommented:
On an SR520, this is certainly possible from the CLI.  All you need to do is set up the IP nat statement referencing the IP address tha t you want to use and make sure the ACL permits traffic to it.  Do you need an example?
0
 
sgentryAuthor Commented:
jodylemoine,

Thanks for the confirmation. What I was thinking was something along these lines...

ip nat inside source static 192.168.x.x xx.xx.xxx.xxx
ip nat outside source static tcp 192.168.x.x 80 xx.xx.xxx.xxx 80

Would I still need an ACL for this?
0
All Courses

From novice to tech pro — start learning today.