Silent Install/Profile of Cisco AnyConnect

So I'm doing a silent install of Cisco Anyconnect which works find when deployed by SCCM.

The question I have though is is it possible to add a profile in (whether that's dropping a file?) so that when I install the Anyconnect VPN client the information will already be there so they don't have to fill in 'Connect To' on first startup?

Any help would be greatly appreciated! Thank you!
LVL 1
cjcottonAsked:
Who is Participating?
 
Jimmy Larsson, CISSP, CEHConnect With a Mentor Network and Security consultantCommented:
This can be done by pre-populating a xml profile file. Have a look at this document:

http://www.cisco.com/en/US/docs/security/vpn_client/anyconnect/anyconnect20/administrative/guide/adminapa.pdf

/Kvistofta
0
 
cjcottonAuthor Commented:
Hey Kvis, thanks so much for the fast response! I'm going to try to use this and see if it works properly, but I may not be able to do this till Monday or Tuesday. I will award you the points though once I test it :] Promise!
0
 
Jimmy Larsson, CISSP, CEHNetwork and Security consultantCommented:
Sure, no problems. ;)

/Kvistofta
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.