Solved

VLAN between Dell 3348 and Fortigate

Posted on 2010-11-22
1
1,055 Views
Last Modified: 2013-11-05
The company I work for has had their firewall team setup an interface on our sites Fortigate Firewall with two subnets (one for voice and one for data).  Our data network is 192.168.1.144 subnet 255.255.255.0, and our voice network is 172.20.120.128 subnet 255.255.255.240 with VLAN ID 10.  The gateways programmed onto this device is 192.168.1.145 and 172.20.120.129.

On the internal side of the Fortigate I have a stack of Dell 3348s.  I currently have the switch programmed to have an ip address of 192.168.1.146 using the default VLAN ID 1.  The switch is passing data happily.  I now need to program the switch to handle the voice traffic as well.  

I need to use VLAN ID 10 for the voice traffic.  What do I need to do?  I have listed a few steps but I'm not sure they're correct.  Anyone with this setup able to shed some light?

- Create VLAN 10 on 3348
- Assign VOIP server port on the switch to be in ACCESS mode for VLAN 10
- Place the port conencting the switch and Fortigate into TRUNK mode.

If I place the switch into trunking mode will I need to tell it to allow VLAN 1?  Does this setup seem right?
0
Comment
Question by:HunterAG
1 Comment
 

Accepted Solution

by:
HunterAG earned 0 total points
ID: 34201237
Just as a follow up, I answered my own question.  The process I listed is a pretty good approximation of the steps needed.  Thanks.
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

This article is in response to a question (http://www.experts-exchange.com/Networking/Network_Management/Network_Analysis/Q_28230497.html) here at Experts Exchange. The Original Poster (OP) requires a utility that will accept a list of IP addresses …
#Citrix #Citrix Netscaler #HTTP Compression #Load Balance
Here's a very brief overview of the methods PRTG Network Monitor (https://www.paessler.com/prtg) offers for monitoring bandwidth, to help you decide which methods you´d like to investigate in more detail.  The methods are covered in more detail in o…
This video gives you a great overview about bandwidth monitoring with SNMP and WMI with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're looking for how to monitor bandwidth using netflow or packet s…

758 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

22 Experts available now in Live!

Get 1:1 Help Now