Solved

di-604 open ports fopr 3g microcell

Posted on 2010-11-23
1
734 Views
Last Modified: 2012-05-10
i have a 3g microcell from ATT and i can not get it to work because i have to open ports on teh router. but it wants a internal ip address i do not think the microcellhas a ip address any help out there :)
0
Comment
Question by:zenworksb
1 Comment
 
LVL 17

Accepted Solution

by:
StrifeJester earned 500 total points
ID: 34286440
If its plugged into the network it should have an IP address.  The 3G Microcell uses an IPSEC VPN tunnel and NAT Trans, there should be no need to forward any ports to the device since it goes out over 443 and connects to AT&T's network.  If you have the ports it uses forwarded elsewhere though you may run into troubles.  The only other way to see it is to delete all of your dhcp leases from the router. Then clear the table and plug the #g Microcell in.  Then you will have the MAC address which you can use to forward.
0

Featured Post

Windows Server 2016: All you need to know

Learn about Hyper-V features that increase functionality and usability of Microsoft Windows Server 2016. Also, throughout this eBook, you’ll find some basic PowerShell examples that will help you leverage the scripts in your environments!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
cmd: can't connect using netsh command 14 93
Internet Service Provider 3 50
Linksys e2500 wireless router - should I upgrade 6 25
VMware ESXi vswitch - performance question 2 45
If your business is like most, chances are you still need to maintain a fax infrastructure for your staff. It’s hard to believe that a communication technology that was thriving in the mid-80s could still be an essential part of your team’s modern I…
When you try to share a printer , you may receive one of the following error messages. Error message when you use the Add Printer Wizard to share a printer: Windows could not share your printer. Operation could not be completed (Error 0x000006…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

777 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question