Solved

Cannot boot VM after P2V using XenConvert.

Posted on 2010-11-23
1
1,230 Views
Last Modified: 2012-05-10
Did P2V of W2003 using XenConvert 2.2. It has only C:\ and I shrinked it to 60 GB. Conversion went fine, log file-no problems. Now I cannot boot VM: after half a second of "blue screen" it always restarting.
0
Comment
Question by:fedmilk1
1 Comment
 
LVL 8

Accepted Solution

by:
ShareefHuddle earned 500 total points
ID: 34199091
Can you boot to safe mode? If so turn off "Automatically restart" in Startup and Recovery under System properties. Then you can see what is happening when it blue screens.
0

Featured Post

Microsoft Certification Exam 74-409

Veeam® is happy to provide the Microsoft community with a study guide prepared by MVP and MCT, Orin Thomas. This guide will take you through each of the exam objectives, helping you to prepare for and pass the examination.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

It Is not possible to enable LLDP in vSwitch(at least is not supported by VMware), so in this article we will enable this, and also go trough how to enabled CDP and how to get this information in vSwitches and also in vDS.
Exchange server is not supported in any cloud-hosted platform (other than Azure with Azure Premium Storage).
How to install and configure Citrix XenApp 6.5 - Part 1. In this video tutorial we have explained step by step installation of Citrix XenApp 6.5 Server on Windows Server 2008 R2 is explained in this video. We have explained the difference between…
In this video tutorial I show you the main steps to install and configure  a VMware ESXi6.0 server. The video has my comments as text on the screen and you can pause anytime when needed. Hope this will be helpful. Verify that your hardware and BIO…

803 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question