jpletcher1
asked on
Exchange 2010 Remote Wipe Mobile Device then Re-enable it
When a user loses a windows mobile device and they do a remote wipe on it from the ECP, then later they find it, what is the process for them to start using it again? Do they have to do a hard reset on the device or just re-setup the phone and start syncing again?
This question was on a certification test that I took and I wasn't sure of the answer and I don't have a windows mobile phone on me to try it out with.
This question was on a certification test that I took and I wasn't sure of the answer and I don't have a windows mobile phone on me to try it out with.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
You are welcome - thanks for the points.
Alan
Alan
ASKER