virginie8
asked on
Procurve Switch 5412zl routing port
Hi,
I have a Procurve 5412zl switch on which I enabled routing. It is my central switch. I want to set it as the gateway for all the Vlans. A sonicwall connected to the main switch provides internet access for the network.
I have 2 problems:
1- I want the DHCP requests for all Vlan (except VLAN 10) to be redirected to the Sonicwall. I plan to use ip helper-address. Hope it's gonna work. Do you have advice about this?
2- I want the users to be able to access the internet (from all Vlans). I don't know how the configure the link between the switch and the sonicwall. I tried a configuration with "no switchport" in Packet Tracer and it was successful. But this command doesn't exist for HP ProCurve...
I have a Procurve 5412zl switch on which I enabled routing. It is my central switch. I want to set it as the gateway for all the Vlans. A sonicwall connected to the main switch provides internet access for the network.
I have 2 problems:
1- I want the DHCP requests for all Vlan (except VLAN 10) to be redirected to the Sonicwall. I plan to use ip helper-address. Hope it's gonna work. Do you have advice about this?
2- I want the users to be able to access the internet (from all Vlans). I don't know how the configure the link between the switch and the sonicwall. I tried a configuration with "no switchport" in Packet Tracer and it was successful. But this command doesn't exist for HP ProCurve...
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER