Solved

limiting bandwidth on cisco router wan interface using SDM

Posted on 2010-11-29
1
813 Views
Last Modified: 2012-05-10
hello Expert,

How do i limit bandwidth on a wan interface using SDM gui .

Regards
0
Comment
Question by:jomfra
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 12

Accepted Solution

by:
Fidelius earned 125 total points
ID: 34267422
Hi,

I think you can configure that through QoS policy. Here is example.
http://www.cisco.com/en/US/docs/routers/access/cisco_router_and_security_device_manager/application/notes/QOS-an.pdf

Hope it helps!

Regards!

0

Featured Post

Don't miss ATEN at NAB Show April 24-27!

Visit ATEN at NAB Show to learn how our "Seamlessly Entertaining" solutions deliver fast, precise video streaming without delays for the broadcasting and media environment. ATEN will showcase its 16x16 Modular Matrix Switch (VM1600) and KVM Over IP Solution (KE6900 series).

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

This article is a guide to configure bridging on Cisco Routers.  This is something I never knew was possible until after making a few phone calls to Cisco.  Using bridging saved our company money by not requiring us to purchase a new switch.  Bridgi…
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

730 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question