Link to home
Start Free TrialLog in
Avatar of supportols
supportols

asked on

Cisco 2811 with 3 ADSL WAN interface

Hi, I've got 1 CISCO 2811 with 3 ATM ADSL interface ,

I want to load balancing all traffic accross all 3 interfaces , how's best way ??
I think GLBP is the better protocol to configure but , is it possible configure GLBP only over 1 ROUTER?
Someone can post some configuration example to do load balancing ??

Thanx in advance.
Avatar of norgetek
norgetek
Flag of United States of America image


GLBP is a first hop redundancy protocol like VRRP and HSRP.  It does not load balance traffic out the other side like you are thinking with a single router.

If all the 3 ADSL interfaces do to the same destination you could implement per-packet load sharing assuming the routing is setup properly.

Here is a quick reference:

http://www.jlsnet.co.uk/index.php?page=cc_t1load


Avatar of supportols
supportols

ASKER


all 3 adsl lines were purchased for the purpose of internet browsing,  I would like all 3 lines were used simultaneously...so I need to apply

ip load-sharing per-packet  


On all 3 interfaces and done ??

ASKER CERTIFIED SOLUTION
Avatar of lomejordeesto
lomejordeesto

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
SOLUTION
Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
Avatar of Qlemo
This question has been classified as abandoned and is being closed as part of the Cleanup Program. See my comment at the end of the question for more details.