sarangi_master
asked on
AIR-AP1252AG CISCO ACCESS POINT NOT PICKING UP IP ADDRESS
I have a air-ap1252ag-e-k9 access point, when I plug it in and connect to my network it does not pick up an IP address from the DHCP server. Also the LEDS are producing the following colours:
Ethernet: flashing green
Status: flashing green, red, yellow one after the other
Radio: flashing red fast
Has anyone any ideas what the problem could be, my dhcp server is not picking up the access point which is cabled into my router.
Ethernet: flashing green
Status: flashing green, red, yellow one after the other
Radio: flashing red fast
Has anyone any ideas what the problem could be, my dhcp server is not picking up the access point which is cabled into my router.
configure your access point as a DHCP server.
ASKER
I cannot access my access point because it has not got an IP address, how am i supposed to configure the AP via a browser if it does not have an IP ??
http://192.168.0.1
or check manual of your AP
or check manual of your AP
ASKER CERTIFIED SOLUTION
membership
Create a free account to see this answer
Signing up is free and takes 30 seconds. No credit card required.
ASKER
Nobody else could come up with any solutions so had to find out myself .